Plasma Aluminium Diecasting Blog -

Gravity Die Casting vs High Pressure Die Casting: Which Is Right for Your Part?

▶ HPDC produces cycle times of 15 to 45 seconds versus GDC’s 2 to 5 minutes, making HPDC the choice […]

Introduction: Why Location Matters in Die Casting Supply Chains If a Tier-1 supplier from Chakan MIDC requires a large quantity

► Flash is a thin fin of aluminium formed at the parting line, gate, vent or ejector pin locations when

► Gravity die casting (GDC) using permanent metal dies achieves as-cast surface roughness of Ra 3 to 6 micrometres, versus

► Plasma Aluminium Diecasting provides first-article samples within 6 to 10 weeks of drawing freeze and tooling PO — covering

► Automotive and two-wheeler manufacturing is the largest end-use sector for aluminium die casting in Pune, accounting for approximately 60

► LPDC fills the die from below using controlled gas pressure (0.5 to 1.0 bar) on the melt surface, producing

► Die casting tooling is a capital investment, not a consumable — the die is paid for once and produces

► Dimensional inspection of aluminium die cast parts should cover all print-critical dimensions using calibrated gauges or CMM, with Cpk